STM32 Nucleo-F303K8

Caution

This page is automatically generated from RIOT doxygen documentation. If you find any issues or have suggestions for improvement, please report them on Github.

View Doxygen Documentation View this board's documentation as generated by Doxygen.

View on GitHub View this board's source code on GitHub.

Tip

When using this board with RIOT, set the BOARD variable to nucleo-f303k8 in your Makefile. If you follow the standard RIOT project structure, your Makefile should look like this:

./Makefile

# name of your application
APPLICATION = hello-world

# Change this to your board if you want to build for a different board
BOARD ?= nucleo-f303k8

# This has to be the absolute path to the RIOT base directory:
RIOTBASE ?= $(CURDIR)/RIOT

include $(RIOTBASE)/Makefile.include

Support for the STM32 Nucleo-F303K8

Overview

The Nucleo-F303K8 is a board from ST’s Nucleo family supporting a ARM Cortex-M4 STM32F303K8 microcontroller with 12KiB of RAM and 64KiB of ROM.

You can find general information about the Nucleo32 boards on the boards_common_nucleo32 page.

Pinout

Hardware

MCU

MCU	STM32F303K8
Family	ARM Cortex-M4F
Vendor	ST Microelectronics
RAM	12KiB
Flash	64KiB
Frequency	up to 72MHz
FPU	yes
Timers	8 (4x 16-bit, 1x 32-bit [TIM2], 2x watchdog, 1x Systick)
ADCs	2x 12-bit (9 channels)
UARTs	2
SPIs	1
I2Cs	1
RTC	1
Vcc	2.0V - 3.6V
Datasheet	Datasheet
Reference Manual	Reference Manual
Programming Manual	Programming Manual
Board Manual	Board Manual

Implementation Status

Device	ID	Supported	Comments
MCU	STM32F303K8	partly	Energy saving modes not fully utilized
Low-level driver	GPIO	yes
	PWM	one PWM
	UART	three UART
	I2C	two I2C
	SPI	two SPI
	USB	no
	Timer	one 32 timer

Flashing the Board

A detailed description about the flashing process can be found on the guides page. The board name for the Nucleo-F303K8 is nucleo-f303k8.