STM32 Nucleo-F411RE

View Doxygen Documentation View this board's documentation as generated by Doxygen.

View on GitHub View this board's source code on GitHub.

When using this board with RIOT, set the BOARD variable to nucleo-f411re in your Makefile. If you follow the standard RIOT project structure, your Makefile should look like this:

# name of your application
APPLICATION = hello-world

# Change this to your board if you want to build for a different board
BOARD ?= nucleo-f411re

# This has to be the absolute path to the RIOT base directory:
RIOTBASE ?= $(CURDIR)/RIOT

include $(RIOTBASE)/Makefile.include

Support for the STM32 Nucleo-F411RE

Overview

The Nucleo-F411RE is a board from ST’s Nucleo family supporting a ARM Cortex-M4 STM32F411RE microcontroller with 128KiB of RAM and 512KiB of Flash.

You can find general information about the Nucleo64 boards on the boards_common_nucleo64 page.

Hardware

Nucleo64 F411RE

Pinout

Pinout for the Nucleo-F411RE (from STM user manual UM1724, http://www.st.com/resource/en/user_manual/dm00105823.pdf, page 32)

MCU

MCU	STM32F411RE
Family	ARM Cortex-M4F
Vendor	ST Microelectronics
RAM	128KiB
Flash	512KiB
Frequency	up to 100MHz
FPU	yes
Timers	11 (2x watchdog, 1 SysTick, 7x 16-bit, 1x 32-bit [TIM2])
ADCs	1x 12-bit (16 channels)
UARTs	3
SPIs	5
I2Cs	3
RTC	1
USB	1
Vcc	1.7V - 3.6V
Datasheet	Datasheet
Reference Manual	Reference Manual
Programming Manual	Programming Manual
Board Manual	Board Manual

Implementation Status

Device	ID	Supported	Comments
MCU	STM32F411RE	partly	Energy saving modes not fully utilized
Low-level driver	GPIO	yes
	PWM	yes (7 pins available))
	UART	3 UARTs	USART2 via STLink/USB or D0(RX)/D1(TX), USART1 on PA10(RX)/PA9(TX) and USART6 on PA12(RX)/PA11(TX)
	I2C	1 I2C
	SPI	1 SPI
	USB	no
	Timer	1 32 bit timer (TIM5)

Flashing the Board

A detailed description about the flashing process can be found on the guides page. The board name for the Nucleo-F411RE is nucleo-f411re.